I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

I encountered a problem when debugging the HRPWM. The EPWMCLK is 100MHz，I think the MEP_ScaleFactor should be 65 or 66 cause the MEP step size is 150ps. But when I use the SFO function, the ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...

I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.

My account has several questions about BSL invoke. Is it possible to call the BSL after the program is started by enabling the BSL invoke pin? If the BSL invoke pin can be used to call the BSL after ...

I am trying to use TPS61165 IC. I am using this IC for LCD Back light control, Which has 27 LED (3S ,9P). Required LCD backlight forward voltage: 9.6V (Typ) Required LCD backlight forward Current: ...

I start to familiarize myself with the new TPLD devices and I built a test-file for different delay options. Your suggestion above seems to work in my file, but the ...

I'm attempting to create a dual integrator to measure distance from an accelerometer. We have the ACF2101 but we need a larger capacitor for the integration time which is 2 seconds. Schematic is here.

I am using the EMIF interface to access both an external SRAM and an FPGA. Do you recommend adding series resistors (10-22 ohms each) to the EMIF signal lines, since the interface will be running at ...

I cannot find absmax drive current for the SPI1_SCLK pin. Our design has 2 processors sharing the same copper for the SPI bus. One drives the SPI bus while the other processor is booting. I would like ...